INSTALLATION AND SAFETY INSTRUCTIONS
FOR YOUR SAFETY ASSEMBLY
GENERAL
WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU
ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED
OR THE CIRCUIT BREAKER OFF.
You don’t need special tools to install this fixture. Be sure to follow the
steps in the order given. Under no circumstances should a fixture be
hung on house electrical wires, nor should a swag type fixture be
installed on a ceiling which contains a radiant type heating system.
Read instructions carefully. If you are unclear as to how to proceed,
consult a qualified electrician.
NOTE: Proper wiring is essential for the safe operation of this
fixture.
Carefully remove the fixture from the carton and check that all parts
are included, as shown in Figure 1 & 2. Be careful not to misplace
any of the screws or parts which are needed to install this fixture.
STEP 1:
STEP 2:
CAGE (F)
FITTER (M)
FINIAL (B)
Unscrew finial (B) and remove top break (C), and roof (A) from
nipple (E).
TOP BREAK (C)
WARNING
NOTE: DO NOT INSTALL ON A POST OR A POLE THAT
RESULTS IN A VERTICAL RISE OF 25 FEET OR HIGHER.
ROOF (A)
NIPPLE (E)
*POST
*NOT SUPPLIED FIG. 1
Installation And
Safety Instruction
HC-405
040699
Fill In Item Number On Carton And
File This Sheet For Fixture Reference. ITEM#_______________
CANDLE
COVERS
NOTE: This glass is handcrafted, the slight imperfections in
the glass add to the authenticity of the fixture.
Kommentare zu diesen Handbüchern