Sea gull lighting 8607-12 Installationsanleitung

Stöbern Sie online oder laden Sie Installationsanleitung nach Nein Sea gull lighting 8607-12 herunter. Sea Gull Lighting 8607-12 Installation Guide Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
INSTALLATION AND SAFETY INSTRUCTIONS
FOR YOUR SAFETY
ASSEMBLY
GENERAL
WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU
ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED
OR THE CIRCUIT BREAKER OFF .
You don’t need special tools to install this fixture. Be sure to follow the
steps in the order given. Under no circumstances should a fixture be
hung on house electrical wires, nor should a swag type fixture be
installed on a ceiling which contains a radiant type heating system.
Read instructions carefully. NOTE: Read the instructions carefully. If
you are unclear as to how to proceed, consult a qualified
electrician.
Carefully remove the fixture from the carton and check that all parts
are included, as shown in Figure 1 & 2. Be careful not to misplace
any of the screws or parts which are needed to install this fixture.
NOTE: Illustration is only intended for easy identification of
parts and is in no way a representation of your particular
fixture. Your fixture may not use every part shown in
illustration.
Installation And
Safety Instruction
HC-412
100101
Fill In Item Number On Carton And
File This Sheet For Fixture Reference. ITEM#_______________
CAUTION: ONLY AIM SHADE BELOW HORIZONTAL
GREEN
GROUNDING
SCREW (G)
NIPPLE (E)
*OUTLET BOX
SCREWS
MOUNTING BAR (D)
*WIRE CONNECTORS
*GROUND WIRE
*OUTLET BOX
GROUNDING AND MOUNTING BAR LOCK UP
FIGURE 2
*NOT INCLUDED
NUT (E)
NUT (E)
*WIRE CONNECTOR
NIPPLE (F)
CANOPY (B)
SWIVEL SCREW (A)
(FOR SHADE ANGLE)
FIGURE 1
*NOT SUPPLIED
*OUTLET BOX
SHADE (C)
CAP NUT (J)
Seitenansicht 0
1 2

Inhaltsverzeichnis

Seite 1 - Safety Instruction

INSTALLATION AND SAFETY INSTRUCTIONSFOR YOUR SAFETYASSEMBLYGENERALWARNING: BE SURE THE ELECTRICITY TO THE WIRES YOUARE WORKING ON IS SHUT OFF. EITHER

Seite 2 - POWER SUPPLY WIRES

GROUNDING INSTRUCTIONS: The green grounding screw is to beinserted into the hole with two raised dimples provided on the mounting bar. Wrap the ground

Kommentare zu diesen Handbüchern

Keine Kommentare